Jump to content


Photo

Is it booted from SD or NAND?

linux ubuntu lubuntu 14 nand sd boot check

  • Please log in to reply
3 replies to this topic

#1 LS-Support-12

LS-Support-12

    Forum Support

  • Moderators
  • 326 posts

Posted 25 September 2015 - 06:50 AM

I have seen this link.

 

However, after cloning NAND to SD and restarting, my result of 'df -h' is different from both photos in the tutorial (my output is here).

 

I think that my pcDuino booted from SD. I have two reasons. First one is that /dev/mmcblk0p1 is listed on the output of 'df -h'. Other reason is that when I run board-config.sh, I have no option to clone my system to SD card anymore.

 

However, I would like to hear your opinion, is it booted from SD or NAND?

 

Also, why the output I have is different from both outputs in the tutorial?


  • lethais60 likes this

#2 cwilt

cwilt

    Advanced Member

  • Members
  • PipPipPip
  • 1,012 posts

Posted 26 September 2015 - 10:27 AM

Looks like its booted from SD to me. If you are running gui open up disk utility. Assuming your sd card is larger than 4gb you will see the freespace.
  • LS-Support-12 likes this

#3 LS-Support-12

LS-Support-12

    Forum Support

  • Moderators
  • 326 posts

Posted 27 September 2015 - 05:10 AM

Looks like its booted from SD to me. If you are running gui open up disk utility. Assuming your sd card is larger than 4gb you will see the freespace.

It is definitely SD. I am not sure about the free space you're talking about (SD is 16 GB), but I have found it the other way. When I remove the SD from pcDuino it stops working. :D :D :D



#4 cwilt

cwilt

    Advanced Member

  • Members
  • PipPipPip
  • 1,012 posts

Posted 27 September 2015 - 10:18 AM

Then there is that way. A little rough on the filesystem though.
  • LS-Support-12 likes this





Also tagged with one or more of these keywords: linux, ubuntu, lubuntu, 14, nand, sd, boot, check

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users