Jump to content


Photo

Linker Kit Baseboard Specification + IR Receiver + Raspberry


  • Please log in to reply
No replies to this topic

#1 oppemaniac

oppemaniac

    Newbie

  • Members
  • Pip
  • 5 posts

Posted 03 April 2016 - 10:45 PM

Hey Folks,

 

I have the Linker Kit Base Shield with the MCP3008 for the Raspi B+. Unfortunately, your wiki only contains the smaller one with the MCP3004. The latter has the correct PIN numbers written on the board, mine has seemingly wrong (or confusing) Pin numbers.

 

I need the specification like this from your wiki.

 

Specification

There are 8 4-pin 2.54mm spacing housing on the base shield:

  • JP1: A0, A1, VCC, GND.
  • JP2: A2, A3, VCC, GND.
  • JP3: SCL, SDA, VCC, GND.
  • JP4: RXD, TXD, VCC, GND.
  • JP5: P17, P18, VCC, GND.
  • JP6: P27, P22, VCC, GND.
  • JP7: P23, P24, VCC, GND.
  • JP8: P24, P4, VCC, GND.

These connectors cover Analog, I2C, and GPIO.

 

 

Specifically, I want to connect your IR Receiver to the Raspberry via the Base Shield. But which Digital Port must I use? Which one is Raspi's native GPIO18?






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users