Jump to content


Photo

Grbl v1.1


  • Please log in to reply
2 replies to this topic

#1 agarza

agarza

    Newbie

  • Members
  • Pip
  • 2 posts

Posted 19 March 2017 - 02:10 AM

Does anyone know if we can flash the Grbl v1.1 on the woodpecker cnc board?



#2 chronoglass

chronoglass

    Newbie

  • Members
  • Pip
  • 6 posts

Posted 11 June 2017 - 10:01 PM

just succesfully flashed it using the arduino IDE

following the steps outlined here
https://github.com/g.../Compiling-Grbl

 

IDE settings were as follows:

board: Arduino duemilanove or diecimilia

Processor: ATmega328

port: /dev/cu.wchusbserial1410

 

this was on OSX

 

edit: on that note.. can someone post the response to a $$ on the default machine? hahaha



#3 ira

ira

    Newbie

  • Members
  • Pip
  • 6 posts

Posted 20 January 2018 - 09:45 PM

Don't know if you still need the default settings, but here they are:

 

$0=10 (step pulse, usec)

$1=25 (step idle delay, msec)

$2=0 (step port invert mask:00000000)

$3=5 (dir port invert mask:00000101)

$4=0 (step enable invert, bool)

$5=0 (limit pins invert, bool)

$6=0 (probe pin invert, bool)

$10=3 (status report mask:00000011)

$11=0.010 (junction deviation, mm)

$12=0.002 (arc tolerance, mm)

$13=0 (report inches, bool)

$20=0 (soft limits, bool)

$21=0 (hard limits, bool)

$22=0 (homing cycle, bool)

$23=0 (homing dir invert mask:00000000)

$24=25.000 (homing feed, mm/min)

$25=500.000 (homing seek, mm/min)

$26=250 (homing debounce, msec)

$27=1.000 (homing pull-off, mm)

$100=800.000 (x, step/mm)

$101=800.000 (y, step/mm)

$102=800.000 (z, step/mm)

$110=800.000 (x max rate, mm/min)

$111=800.000 (y max rate, mm/min)

$112=500.000 (z max rate, mm/min)

$120=10.000 (x accel, mm/sec^2)

$121=10.000 (y accel, mm/sec^2)

$122=10.000 (z accel, mm/sec^2)

$130=200.000 (x max travel, mm)

$131=200.000 (y max travel, mm)

$132=200.000 (z max travel, mm)

ok






0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users