Jump to content


How to Flash LinkNode R4


No replies to this topic

#1 Guest_Derek McFarland_*

Guest_Derek McFarland_*
  • Guests

Posted 26 August 2017 - 11:57 PM

I am having trouble flashing a LinkNode R4 with an .ino that will allow my home automation system to control the R4 relays. http://forums.indigo...p?f=178&t=14043

 

With the jumper in the boot from flash position, I see:

 ets Jan  8 2013,rst cause:1, boot mode:(1,6)

 

With the jumper in the boot from flash position, I see:

ets Jan  8 2013,rst cause:1, boot mode:(3,6)
 
 
load 0x4010f000, len 1264, room 16
tail 0
chksum 0x0f
csum 0x0f
~ld
Thru serial monitors set at 74880 Baud, N81.  All other bauds show junk.  I get esp8266_comm_sync errors when uploading from Arduino IDE and Platformio.  I am used to using 11520 Baud, so I tried AT commands with no success.  What am I missing?  My R4 has done nothing but reset every two seconds in either mode since power has been applied.  I'd like to put it to use.
 
Regards,
Derek McFarland
 




Reply to this topic



  


0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users