Jump to content
jim

rS485 shield for PI

Recommended Posts

Dear Tech Support:

 

I am following the instructions on the wiki http://learn.linksprite.com/raspberry-pi/shield/user-tips-of-rs485-shield-for-rpi/ and am able to read data from my PC USB2RS485 device, however, attempts to write data results in dropped bits. The tx/rx lights on both the shield and my PC USB device light when the data is sent from the Pi, however, I'm unable to read the data correctly. I've tried several PC "terminal" type programs including reading the comm port directly via a program that I wrote.

I've tried writing via Python (the linksprite example), Java and minicom on the PI. All have the same result....reading is fine (data sent from the PC), however, data send back to the PC is not complete.

Can you offer any help with this problem? Thank you.

Share this post


Link to post
Share on other sites

Not the same question, but very related.
My plan is to interface a kWh-meter type DDS238-1: it has a 2-wire RS485-interface applying Modbus-protocol.

;-) One step further than just message-handshaking.
Any forum-member with Modbus-experience applicable for this RS485-interface & Raspberry?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×