Jump to content
Sign in to follow this  
jim

Need assistance in getting powerline communication

Recommended Posts

am working on school project that requires power line communication module. 

 
We have purchased the following module: 

http://store.cutedigi.com/narrow-band-powerline-communication-module-with-simple-mac/  

We followed the setup as shown in the documentation, however we are unable to get serial communication across a power line.  

We are using Arduino to generate serial RS232 signals which we transmit into the PLC modules. Again, we are unable to capture the signal on the other PLC module on the same power line.  

Attached you can see the setup we have. Similar to what the documentation had. 

 

Please see if you can help us to get this to work. 

Let us know if you need any more information. 
Thanks.

 

 

Share this post


Link to post
Share on other sites

 

Yes we did - we removed the Atmega chip as suggested in the link. 

 
It still doesn't work. We are working in USA - 110 Volts.  

 

Did the wire connections is right? RX,TX,GND

 

Was the baud rate setting 19200?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×