Jump to content
jscottb

Initial state of the GPIO's upon power up?

Recommended Posts

Thanks. I have updated it some, but I assume it's just the updates for the pcduino1.  I have written a script that I have placed into init.d that drives them all low, but guess the real problem now for me is before that point with them being all high. This wreaks a bit of havoc on my robot at boot time  :D.  For now I have offloaded the motor control to a micro controller and use i2c to do that drive that function of the bot.  It would be nice to just to use the T-board and a motor shield.

 

Thanks again for the info.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×