Jump to content
Sign in to follow this  
sgmustadio

Cannot Boot Acadia with New Image

Recommended Posts

I am trying to boot the Acadia from either image (SD boot or eMMC boot) using the instructions here.

 

1. SD Boot

 

Booting from SD card works initially but hangs with the message:

 


 

mmc2: host does not support reading read-only switch. assuming write-enable.

mmc2: new high speed SDHC card at address dfc7

mmcblk0: mmc2:dfc7 SE08G 7.2 GiB

 mmcblk0: p1

 

 

20150630_120909.jpg

 

2. eMMC Boot

 

Nothing happens. As it turns out, the hardware version I have (Acadia 1 V3.0) does not have configuration switches (the DIP switches just above the CPU are not populated). This makes following the guides (specifically the parts about setting the DIP switches to configure eMMC boot) a little difficult.

 

20150630_120954.jpg

 

Please help! I cannot get the Acadia to do anything at this point.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×