Jump to content
Sign in to follow this  
LS-Support-12

Is it booted from SD or NAND?

Recommended Posts

I have seen this link.

 

However, after cloning NAND to SD and restarting, my result of 'df -h' is different from both photos in the tutorial (my output is here).

 

I think that my pcDuino booted from SD. I have two reasons. First one is that /dev/mmcblk0p1 is listed on the output of 'df -h'. Other reason is that when I run board-config.sh, I have no option to clone my system to SD card anymore.

 

However, I would like to hear your opinion, is it booted from SD or NAND?

 

Also, why the output I have is different from both outputs in the tutorial?

Share this post


Link to post
Share on other sites

Looks like its booted from SD to me. If you are running gui open up disk utility. Assuming your sd card is larger than 4gb you will see the freespace.

It is definitely SD. I am not sure about the free space you're talking about (SD is 16 GB), but I have found it the other way. When I remove the SD from pcDuino it stops working. :D :D :D

Share this post


Link to post
Share on other sites

I have a similar question, I would like to clone my NAND content (image) to the SD by doing a backup You got it?

I have a similar question, I would like to clone my NAND content (image) to the SD by doing a backup You got it?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×