Jump to content
Sign in to follow this  
pirpi

USB Camera is not working with Pcduino8 beta arches

Recommended Posts

Hi,

 

I have a pcduino8 beta arches board. I am trying to connect my usb camera with pcduino8 beta board. But pcduino8 board is unable to detect it. I have added following lines in the /etc/modules to enable the camera drivers.

 

gc0308

gc2035

ov5640

sun4i_csi0 i2c_addr=0x42 ccm=“gc0308”

sun4i_csi0 i2c_addr=0x78 ccm=“gc2035”

sun4i_csi0 i2c_addr=0x78 ccm="ov5640"

 

But after adding above lines also I am unable to get /dev/video device.

 

Thanks

pirpi

 

Share this post


Link to post
Share on other sites

What kind of USB camera do you use? Maybe there is no Linux driver supporting you USB module.

 

1. lsusb to find your usb deivce

2. lsmod to find Linux driver that have been installed

3. Is there linux module for your USB device?

4. dmesg to get the information logged from kernel.

Share this post


Link to post
Share on other sites

Thanks for your reply.

 

I am using Logitech HD USB camera. The same camera I am using for the pcduino3, with pcduino3 it is working fine. I have one more mini webcam, with that also it is not working. Infact I checked with dmesg, it is not showing any kernel log messages for the USB camera.

 

Help me with this.

 

Thanks

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×