Jump to content
Sign in to follow this  
FRL

PCDUINO 3A WIFI low range

Recommended Posts

Hello,

 

The range of my PCDUINO is short.

I thought if the distance increases, the bitrate decreases, but not.

 

iwconfig gives :

"wlan0     IEEE 802.11bgn  ESSID:"*********"  Nickname:"<WIFI@REALTEK>"
          Mode:Managed  Frequency:2.437 GHz  Access Point: **************
          Bit Rate:72.2 Mb/s   Sensitivity:0/0
          Retry:off   RTS thr:off   Fragment thr:off
          Power Management:off
          Link Quality=95/100  Signal level=-60 dBm  Noise level=0 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0"

 

if I remove the PCDUINO one meter, I lose the connection. I can't change bit rate with "sudo iwconfig wlan0 rate 54M fixed". No effect.(ifconfig wlan0 down before and ifconfig wlan0 up after).

 

What can I do for increase the range ?

 

Thanks
 

Share this post


Link to post
Share on other sites

Thanks for you interest.

 

No, it is the usb dongle on board.

 

I observed that the bit rate change whit the channel that is used by the router. On channel 11 it is 150 Mb/s and the range is shorter. On channel 6 it is 72,2 Mb/s.

Once established, the bit rate don't change. Closer or farther, it's 72Mb/s on channel 6 or 150 Mb/s on channel 11.

 

If the channel change, the connexion is lost. I have to declare a new connexion with wicd (Ubuntu 14).

The module used is 8188cu.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×